Rail Fall Arrest System, I-Beam Clamp
Horizontal Rails- The simplicity of the ARFAS componentry translates to a wider variety of mounting options, and a much more versatile method of mitigating fall protection challenges. Multiple rail systems can be connected to provide a high degree of fall protection coverage.
- The rail is extruded from a rugged, durable aluminum alloy at a standard 16ft segment requireing no intermediate support, and can cantilever up to 5ft
- Splicing simply slides over the top of two adjacent segments and joins them together by through the tightening of 8 simple fasteners.
- The Hangers are installed on top of the rail segment at or adjacent to each end at each splice location. All that is required is a simple twist of the wrist and the tightening of two set screws.
- The trolley is forged from Stainless Steel and featuring UHMW wheels and sealed bearings. The oblique orientation of the wheels allows the trolley to run true, eeven when travelling parallel to, but directly beneath the rail.
Available Variations & Documents
- Warranty
- 1 Year Limited Commercial Warranty
- System Component
- Yes
- Special Features
- I-Beam Clamp Vertical Flange
Frequently Asked Questions
Up to 4 workers, depending on the system's span and the connecting devices used. Some configurations are limited to 2. Check the Skyline technical bulletins or contact Fall Safe technical services to confirm the capacity for your layout.
Yes. Skyline horizontal lifelines should be installed by trained personnel, and Fall Safe offers Skyline training classes. OSHA also requires horizontal lifelines to be designed, installed and used under the supervision of a qualified person, as part of a complete system with a safety factor of at least two (29 CFR 1926.502(d)(8)).
At least once a year, by a competent person trained in Skyline inspection. Users should also inspect the system before each use. Any system that has arrested a fall must be removed from service until a competent person inspects it.
At least once a year, by a competent person trained in ARFAS rigid rail inspection. Users should also inspect the system before each use. Any system that has arrested a fall must be removed from service until a competent person inspects it.
A rigid rail doesn't deflect in a fall, so the fall clearance you need depends mainly on the connecting device, such as an SRL. A cable horizontal lifeline sags under load, which usually adds to the clearance required. That makes rigid rails a good fit where clearance below the work area is limited.
The ARFAS is built from a small set of simple components, which allows a wide range of mounting options. Multiple rails can be connected to cover larger work areas, and its lightweight design is intended to make installation faster and less costly.
When the ARFAS is installed overhead and paired with a Fall Safe FLO or Skyloc II SRL, arrest distances can be less than 24 in. The system is designed for permanent installation indoors or outdoors in a wide range of environments.
)
Unsure what gear is right for your needs?
Our experienced team of Fall Safety experts can help.